Fuselage Construction Cont.
The next three steps place the motor mount stick
in the proper position for the GWS EPS350C-CS
motor and gearbox. If you intend to run a
brushless motor system you will need to adjust
the position of the mount stick further aft. The
only reliable way to do this is to test fit your motor
and mount before setting the stick position within
the fuselage.
☐
Mark motor mount 3/16 in. from one end.
☐
Install motor mount through formers F2 and
F3. Align mark flush with rear face of F3.
☐
Build up a fillet of medium CA around motor
mount on both sides of F2 and F3.
☐
Install F8 on top of FD Fuselage Doublers,
between FS Fuselage Sides, and interlocking
with tabs on F2 and F3.
☐
Coat F8 with thick CA and install F9 on top of
F8, tabbing into fuselage sides.
☐
Bond WSS Windshield Supports within
fuselage into pockets created by FD and FS.
SkyBuggy © 2010 Stevens AeroModel all rights reserved.
Page 12 of 30
F8
F9
Windshield Supports
3/16 inch
F3
F3
F2
FD
FS
FS
