Fuselage Construction Cont.
☐
Bond H1a and H1b together to create part
H1.
Note: Ensure that etch marks face up.
☐
Coat Hatch Doubler H2 with thick CA and
align over H1, between guide lines along
sides. Ensure vent openings in both parts are
aligned together.
☐
Fit tabs of hatch rails H3 within notches of
H2. Bond with CA glue.
☐
As first magnet was previously installed within
the Hatch Retainer assembly, It will be
important to match the proper orientation
(polarity) of the remaining magnet prior to
installing within the battery hatch.
To identify the proper installation polarity of
second magnet, allow second magnet to snap
against magnet installed within Hatch
Retainer and mark the outside surface of
second magnet with a permanent marker.
Now fit second magnet within H2 marked side
facing inside pocket. Once again test the
parts to ensure that magnets attract and do
not repel each other. Once satisfied that
second magnet has been properly fit within
Battery Hatch, bond with CA glue.
☐
Your fuselage is complete. Sand it smooth
and round the corners. Leave the corners in
the wing saddle area square.
SkyBuggy © 2010 Stevens AeroModel all rights reserved.
Page 16 of 30
H1a
H1b
H2
H1
H3
Vent
H2
Square
H2
