Fuselage
(continued)
25.
Align and bond the
rear
fuselage stringer, parts F22a and F22b (sheet 02/08, 1/20 in. balsa)
together. Fit them into the notches at the
top
of formers F9, F12 and F13. Bond with CA.
26.
Fit
front
fuselage stringer F23a (sheet 02/08, 1/20 in. balsa) into the slot at the
top
of former
F6, and the notches in formers F20 and F21.
27.
Fit the forward fuselage sheet part F23b (sheet 03/08, 1/20 in. balsa) to the tab at the
top
of
former F6 and to the tab at the
rear
of F23b. Bond the
rear
of F23b to former F21. Gently
bend F23b around the
top
of F6, and bond.
28.
Fit the remaining nose sheeting parts F24 (sheet 05/08, 1/20 in. balsa and sheet 06/08,
1/20 in. balsa) to each side of the fuselage. The tab at the
lower
rear
of F24 will fit in the
notch along the fuselage side at former F21. The
front
of F24 will fit
under
the edge of
F23b. Align F24 so that it is vertical and in line with the fuselage sides F10 and F11. Bond
F24 to the fuselage sides and F6.
29.
Moisten the outside of F24 with glass cleaner and allow it to soak in for a minute or two.
Wrap both F24s
inward
until they mate with F23b. Hold both F24s in place with low tack
masking tape until dry.
30.
Fit the rear cockpit sides, parts F25 (sheet 05/08, 1/20 in. balsa and sheet 06/08, 1/20 in.
balsa) to the fuselage immediately
behind
both F24s. Align both F25s vertically as done
with parts F24 in Step 28. Bond with CA. Moisten both parts F25 with glass cleaner and
allow to soak for a minute or two. Gently bend the parts F25 until they contact the
top
of
former F9 and the
front
of
rear
fuselage stringer F22. Hold both parts F25 in place and
bond with CA.
Build Instructions
Avro 534 “Baby”
- Build Instructions © 2014 Stevens AeroModel, all rights reserved.
!
Page 14
□
□
□
□
□
□
