Fuselage
(continued)
17.
Assemble the fuselage
bottom
with parts F14a, F14b, and F14c (sheet 03/08, 1/20 in.
balsa) and bond with CA.
18.
Fit the fuselage
bottom
to the
rear
of the fuselage. Fit the tabs on the F14 assembly to the
notches on the
bottom
of the fuselage sides, and that the tabs on formers F9, F12, and F13
are fully seated in the F14 assembly.
19.
Build the landing gear pocket by fitting part F15 (sheet 08/08, 1/32 in. ply) into the angled
notches in the fuselage sides, immediately
behind
former F4a. These notches are slightly
oversized, to accommodate the three parts of the landing gear pocket. Position F15 in the
forward
part of the notches. Next, fit part F16 (sheet 08/08, 1/32 in. ply) immediately
behind
part F15.
20.
Fit F17 (sheet 08/08, 1/32 in. ply) into the notch, immediately
behind
F16. Make sure all
three parts are fully seated in the notch, then wick CA around the edges to bond them to the
fuselage sides.
Ensure no glue enters the landing gear pocket.
21.
Fit and bond part F18 (sheet 02/08, 1/20 in. balsa) to the notches in the fuselage sides,
immediately
behind
the landing gear pocket.
22.
Fit part F19 (sheet 04/08, 1/20 in. balsa) to the
forward
part of the fuselage
bottom
and
bond with CA.
23.
Turn the fuselage
right side up
. Locate the position of former F4a. Fit former F20 (sheet
02/08, 1/20 in. balsa) to the set of slots immediately
forward
of F4a. Bond with CA.
24.
Fit and glue former F21 (sheet 03/08, 1/20 in. balsa) to the set of slots immediately
behind
former F4a.
Build Instructions
Avro 534 “Baby”
- Build Instructions © 2014 Stevens AeroModel, all rights reserved.
!
Page 12
□
□
□
□
□
□
□
□
