STERWINS 3276007088533, Инструкция по сборке, использованию и обслуживанию

Страница: 26 / 43

26
RU
KZ
EN
Problems Probable causes Solutions
Qualification
required
Excessive noise
Nuts / screws are not well
tight
Screw the nut(s) / screw(s)
-
The blade is not enough set Screw the nut(s) / screw(s)
Over-
consumption
There is a leak of oil due
to a defective assembling
(drilled pip/bad connection)
Find the leak location and
replace the part by a new one
After sales
service
Oil leak
The lubricant oil continues
to flow by capillarity
"Check with the after sales
service if the oil pump is not
damaged. Otherwise it's
normal,
let the chainsaw cool while
protecting the ground
(cardboard, towel ...)"
-
Chain breakage
The chain is too tight
Unscrew the chain tightening
screw
-
The chain is not lubricated
enough
Check if the oil tank is not
empty and fill it
The chain is not lubricated
enough
The oil pump is defective,
change it
After sales
service
The chain is not lubricated
enough
Check the setting of the oil
consumption and adjust it
-
The chain is wasted
Remove it and change it by a
new one
Chain guide
breakage
The blade cover is not well
put
Remove the cover and pay
intention to put on the good
position and tight it enough
-
Chain does not
stop on released
trigger
The trigger is blocked on
ON position
Remove the trigger cover and
replace it by a new one
After sales
service
The guide has been stuck
on a branch
Pay attention to initiate the
cup by 3-4 cm blow the branch
and then cut it from above