4
5
sTEP 1 – PrEParaTIoN For mouNTINg ThE FaucET
1
Shut off the water supply.
1 inlet VeRSion
2 inletS VeRSion
2
Remove the hexagonal nut, disk and
washer. Do not remove the O-ring
from the base of the faucet.
nut
disc
washer
O-rinG
3
For Csaba 1000B/E drill a hole in
the counter for the mixing handle.
Remove the nut, disk and seal.
34-36 mm
sTEP 2 – INsTallINg ThE FaucET
1
Place the faucet with O-ring into the
hole in deck or lavatory. Make sure
the O-ring is located between the
deck or lavatory and the bottom of the
faucet.
O-rinG
2
Slide the washer, disk and hexagonal
nut over the flexible hose and secure
the faucet into place.
nut
disc
washer
O-rinG
3
For Csaba 1000B/E
Place mixer in the hole and secure
with nut, disk and seal. Ensure the
mixer is aligned properly
O-rinG
4
1. Connect hot and cold inlet hoses to
the water mains.
2. Connect the outlet from mixer hose
to the Dual Power Input Box
1
nut
2
INsTallaTIoN
INsTallaTIoN
sTEP 3 – coNNEcTINg ThE waTEr suPPly
NOTE: Flow direction is denoted by the arrow on the solenoid housing.
1
Connect the Nipple and FILTER on the inlet
side of the solenoid.
2
Connect the quick connector on the outlet
side of the solenoid.
3
Connect the dual power box to the water
supply lines.
4
Connect the black flexible tube to the quick
connector on the top of the dual power box.
5
For battery versions: Place battery into the
Dual Power input box.
sTEP 4– coNNEcTINg ThE PowEr sourcE
1
Turn on the central water supply. Check for leaks.
Remove the protective sticker from the sensor.
2
Connect the power source.
3
Once the power source is connected,
wait 15 seconds to allow the system
to set the ideal sensor range. A LED
will flash continously to indicate this
adjustment period. The solenoid valve
will open for 1 second to indicate that
the ideal sensor range was set.
15
SECONDS
4
If the automatically adjusted sensor range is not satisfactory to your purposes,
please refer to the section entitled “Settings adjustment”.
