8
9
DELAY IN TIME: It is recommended to change the delay in time for
flush valves for urinals or toilets only.
If required, the delay in time can also be modified in faucets as
follows:
Press the IN button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the delay in
time and – to reduce it.
DELAY OUT TIME: This button allows modifying the water flow
time after the user removes his hands from the faucet. A delay out
time close to 0 will save more water. An increased delay out time
will make the user experience more comfortable.
If required, the delay out time can be modified as follows:
Press the OUT button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the delay out
time and – to reduce it.
24 HOUR HYGIENE FLUSH: This model includes a 24 hours hygiene
flush which is disabled. To activate the hygiene flush, press the
clock button. Wait until a quick flashing of the LED in the sensor eye
is perceived. Then press + to activate the hygiene flush. To disable
it again, press – to deactivate it.
COMFORT FLUSH: If your model includes a Comfort flush setting, it
can be activated by pressing the flush button.
When the button is pressed, one blink of the LED in the sensor eye
is perceived. The pre-programmed flush cycle will take place then.
The Comfort flush cannot be interrupted or deactivated by pressing
any button until it is over.
TEMPORARY OFF FUNCTION: This function is ideal to perform any
kind of activity in front of the sensor without operating the system
(for example, cleaning).
The faucet will remain shut for 1 minute when this button is
pressed once. To cancel this function and to return to normal
operation press the On/Off button again or wait 1 minute.
RESET BUTTON: This function restores all the factory settings
except for the sensor range. If required, press the Reset button
and without releasing it, press the + button once.
note:
To enter the self adjusting mode, use the ADJ button. To change the sensor
range, use the RANGE button.
sETTINgs aDjusTmENT
maINTENaNcE
Battery models only
When the battery weakens, the LED will blink at a constant rate when the user’s hands
are within the sensor range. The battery must be replaced within two weeks.
Always use batteries from a reputable source. Poor quality batteries may affect the
performance of the product.
to replace the battery:
Carefully open the dual power input box using the Allen key provided. Remove the old
battery and replace it with a new 9V battery (Lithium battery is recommended). Close
the box lid and tighten it with the screw.
important:
Spent batteries should not be disposed of with normal
household waste. Contact your local authority for information on waste
disposal and recycling.
baTTEry rEPlacEmENT
filter cleaning instructions
This tap is provided with a stainless steel filter preventing foreign particles to enter the
lines. If the water flow has decreased, this may be because the filter is clogged. The
filter can be cleaned as follows:
1. Shut-off the water shut off valve.
2. Disconnect the water supply pipe from the adaptor and disassemble the filter from it.
3. Wash the filter under running water.
4. Reassemble the parts.
5. Restore the incoming water supply.
6. Make sure that there is no water leakage.
Care and cleaning of chrome and special finishes
DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives, or the
like. Use of any prohibited cleaning or maintenance products or substances could
damage the surface of the faucet. For surface cleaning of faucet us ONLY soap and
water, then wipe dry with clean cloth or towel. When cleaning bathroom tile, the faucets
should be protected from any splattering of harsh cleansers.
If system chemical disinfection is practiced, chlorine can be used (calculated chlorine
concentration of 50mg/l maximum in water per one hour dwell time) at service interval
frequency.
