4
5
FAucET INSTAllATIoN
STEP 1 – PREPARATIoN FoR mouNTINg ThE FAucET
1
Shut off the water supply.
2
Remove the hexagonal nut, the disk
and the gasket. Do not remove the
O-ring from the base of the faucet.
nut
disc
gasket
STEP 2 – INSTAllINg ThE FAucET
1
Place the faucet with O-ring into the
hole in deck or lavatory. Make sure
the O-ring is located between the
deck or lavatory and the bottom of the
faucet.
2
below the deck, slide the gasket, disk
and hexagonal nut over the flexible
hose and secure the faucet into place.
gasket
nut
disc
PRE-INSTAllATIoN INFo
CHECK CONTENTS
Separate all parts from the packaging and check each part with the “Pack
contents” section.
Pay attention to the different models variations.
Make sure all parts are accounted for before discarding any packaging material.
If any parts are missing, do not attempt to install your electronic faucet until you
obtain the missing parts.
WARNINGS
Do not install facing a mirror or any other electronic system operated by an
infrared sensor.
To prevent reflection problems, it is recommended to keep a minimum distance of
1.50 meters between the faucet and any other objects.
PREPARATION FOR INSTALLATION
Flush water supply lines thoroughly before installing the faucet. Do not allow dirt,
Teflon tape or metal particles to enter the faucet.
Shut off water supply.
IMPORTANT
All plumbing is to be installed in accordance with applicable codes and
regulations.
28-29mm
RECOMMENDED HOLE SIzE