Stern Engineering JUPITER 2030, Руководство по установке и обслуживанию

Страница: 5 / 12

3
PRE–INSTALLATION INFO
Check contents
Separate all parts from packaging and check each part with the pack
contents section.
Make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not attempt to install the electronic
flush valve until you obtain the missing parts.
Warnings
Do not install the system facing a mirror or any other electronic system
operated by an infra-red sensor.
To prevent reflection problems, it is recommended keep a minimum
distance of 1.50 meters between the flush valve and other objects.
Preparation for installation
Flush water supply lines thoroughly before installing the flush valve.
Do not allow dirt, Teflon tape or metal particles to enter the flush valve.
All plumbing is to be installed in accordance with applicable codes and
regulations.
Care and cleaning of chrome and special finishes
DO NOT use steel wool or cleansing agents containing alcohol, acid,
abrasives, or the like. Use of any prohibited cleaning or maintenance
products or substances could damage the surface of the flush valve.
For surface cleaning use ONLY soap and water, then wipe dry with
clean cloth or towel. When cleaning bathroom tile, the flush valve
should be protected from any splattering of harsh cleansers.
If system chemical disinfection is practiced, chlorine can be used (calculated
chlorine concentration of 50mg/l maximum in water per one hour dwell time)
at service interval frequency.