10
11
sETTINgs aDjusTMENT
DELAY IN TIME: If required, the delay in time can also be modified as
follows: press the IN button. Wait until a quick flashing of the LED in the
sensor eye is perceived. Then, press + to increase the delay in time and –
to reduce it.
DELAY OUT TIME: This button allows modifying the flushing start time after
the user moves away from the product. A delay out time close to 0 will save
more water. An increased delay out time will make the user experience
more comfortable.
If required, the delay out time can be modified as follows:
press the OUT button. Wait until a quick flashing of the LED in the sensor
eye is perceived. Then, press + to increase the delay out time and – to
reduce it.
TEMpORARY OFF FUNCTION: This function is ideal to perform any kind of
activity in front of the sensor without operating the system (for example,
cleaning).
The product will remain shut for 1 minute when this button is pressed
once. To cancel this function and to return to normal operation press the
On/Off button again or wait 1 minute.
RESET BUTTON: This function restores all the factory settings except for the
sensor range. If required, press the Reset button and without releasing it,
press the + button once.
SECURITY TIME: The Security time, prevents continuous flushing of water
due to reflections or vandalism. By default, if the sensor is covered for
more than 90 seconds the water flow will shut automatically. To resume
regular operation any obstruction must be removed.
press the SEC button. Wait until a quick flashing of the LED of the sensor
eye is perceived. Then, press + to increase the security time and – to
reduce it.
24 hOUR hYGIENE FLUSh: This model includes a 24 hours hygiene flush
which is disabled. To activate the hygiene flush, press the clock button.
Wait until a quick flashing of the LED in the sensor eye is perceived.
Then press + to activate the hygiene flush. To disable it again, press – to
deactivate it.
COMFORT FLUSh: If your model includes a COMFORT FLUSh setting, it can
be activated by pressing the flush button.
When the button is pressed, one blink of the LED in the sensor eye is
perceived. The pre-programmed flush cycle will take place then.
The Comfort flush cannot be interrupted or deactivated by pressing any
button until it is over.
BaTTEry rEPlacEMENT
1
A. Disconnect the water proof
connector between the battery
box and the electronic unit.
B. pull out the battery box
from the battery box holder
by releasing the bottom clip.
C. pull out the battery cover.
A
B
C
2
D. Replace the used battery with
a new 9V battery (Lithium
battery is recommended).
E. Close the battery box and
slide it back on the battery
holder starting from the
bottom upwards.
F. Connect the connectors.
D
E
F
3
IMpORTANT: Wait a few seconds before activating the product.
Close the battery compartment and refit the cover plate.
When the battery weakens, the LED indicator light will blink at a constant rate when
the user’s hands are within the sensor range. The battery must be replaced within
two weeks.
To replace the battery follow the steps below:
IMpORTANT: Spent batteries should not be disposed of with normal household
waste. Contact your local authority for information on waste disposal and recycling.
