Sterling 7115 Series Скачать руководство пользователя страница 4

Страница: 4 / 40

Before You Begin

CAUTION: Risk of product damage.

Do not lift the bath using the apron brace.

Lift the bath by the rim at multiple points. Bath units in a single carton are
shipped with apron braces in the closed position. Connect the apron braces to the
apron

before

removing the unit from the carton(s).

CAUTION: Risk of product damage.

To avoid rust marks on your product,

ensure the roofing nails or non-tapered flathead screws are galvanized or plated. If
using galvanized or plated non-tapered flathead screws,

do not overtighten the

screws.

Excessive tightening can damage the wall flange. Consult local building

codes to determine if the screws or nails must be galvanized or plated.

CAUTION: Risk of property damage.

Only apply 100% silicone sealant to the

areas where instructed to do so. Do not add silicone sealant to any other areas.
The inappropriate use of silicone sealant may trap moisture and could result in
mold, leakage, or mildew. We recommend using colored 100% silicone sealant to
match the color of the product. Use of latex based or other caulks is not
recommended.

NOTICE:

The bath must be installed on an adequately supported, level subfloor. The

basin area requires no additional support when the subfloor is level and square with

the stud framing. Use shims for additional support if the subfloor is uneven. Do not

install the bath over open floor joists.

NOTICE:

The bath cannot be installed without the wall surrounds.

NOTICE:

If your bath is shipped with a liner, keep the liner in place until

construction is complete to prevent surface damage to the unit. If a liner is not

available, place a clean drop cloth or similar material in the bottom of the bath.

NOTE:

7114 and 7124 series models are designed to be used with a single handle

mixer valve with an escutcheon cover not exceeding 7-3/4

″

(19.7 cm) in width.

Read all instructions before you begin.
Observe all applicable plumbing and building codes.
This bath is designed for alcove installations.
Upon receipt, check for shortages or damage. Report any shortages or damage

immediately.
Do not remove the old fixture before you unpack and inspect the new unit.
Store the bath and wall surrounds in a safe place until you begin installation to

avoid damage.
If remodeling, measure the existing framework before removing the old bath to

make sure that the new bath will fit. Make sure that the drain is in the correct

location.
Confirm adequate mounting and connection space for the water supply and drain

installation.
The apron panel is not removable on bath units.

Baths with wall surrounds can be ordered with factory-installed backer kits for grab bars.

Only factory-installed grab bars are shipped as ADA compliant. However, wall

surrounds with backer kits are ADA adaptable if the grab bar design and installation

meet ADA requirements. It is the installer’s responsibility to consider these factors when

supplying and installing grab bars to the factory-installed backer kits.

ADA Considerations

Consider the path of the wheelchair user when building the clear floor space. Be

sure that there is sufficient room for a wheelchair user to enter the room and