6-5
Routine Maintenance
Operator Manual
122997-341
6.4 Weekly Cleaning
Procedures
6.4.1 Clean Washer Exterior
Clean washer exterior with a general purpose cleaner to remove
general stains, a stainless-steel stain remover for stubborn stains,
and a stainless-steel polish to keep equipment looking new.
1.
Using a damp cloth or sponge, apply cleaner in a back-and-forth
motion, in same direction as surface grain.
2.
Thoroughly wipe off cleaner.
3.
Polish surface with a clean, dry and lint-free cloth.
4.
Clean door windows with a general window cleaning product.
5.
Dry window with a lint-free cloth.
6.4.2 Clean Washer Interior
Close steam, hot and cold water lines and wearing appropriate Per-
sonal Protective Equipment (PPE), enter wash chamber and proceed
as follows:
1.
Wash chamber with a mild detergent solution.
2.
Rinse with tap water and dry with a lint-free cloth.
3.
If interior is stained, use a general purpose cleaner to remove
general stains or a stainless-steel remover for stubborn stains, as
follows:
a.
Using a damp cloth or sponge, apply cleaner in a back-and-
forth motion, in same direction as surface grain.
b. Thoroughly wipe off cleaner.
c.
Polish surface with a clean, dry, lint-free cloth.
d. Clean door windows with a general window cleaning
product.
e.
Dry window with a lint-free cloth.
4.
Open steam, hot and cold water lines.
WARNING – ELECTRIC
SHOCK AND/OR BURN HAZ-
ARD: Disconnect all utilities
to washer before servicing.
Do not service washer
unless all utilities have been
properly locked out. Always
follow local occupational
health and safety regula-
tions, as well as electric and
plumbing codes.
CAUTION POSSIBLE EQUIP-
MENT DAMAGE: Use non-
abrasive cleaners when
cleaning unit. Follow direc-
tions on containers and rub
in a back-and-forth motion
(in same direction as sur-
face grain). Abrasive clean-
ers will damage stainless
steel. Cleaners rubbed in a
circular motion applied with
a wire brush or steel wool
will scratch and dull stain-
less steel. Do not use these
cleaners on painted sur-
faces.
WARNING – BURN HAZARD:
Never perform cleaning of
wash chamber until full cycle
has been completed. If cycle
has not been completed,
contaminated debris or water
may remain in the bottom of
the wash chamber.
