> Pull down the strap at the bottom of the cover.
> Remove the front cover by slightly lifting and then pulling it off towards the front.
> Remove the plug and pull the suction pipe out of the empty container.
> Insert the suction pipe with the plug into a full container (up to a maximum
of 1000 ml) and slightly press the plug.
> If the package size is changed, slide the plug up or down the suction pipe.
> Always cover the liquid container with the plug in order to avoid evaporation
of the liquid.
> Move the front cover horizontally towards the device, put it on at the top,
and press the lower part until latched.
> Have the liquid sucked into the device by triggering the sensor several times.
REPLACING THE LIQUID CONTAINER
If the device was not used for a longer period, first rinse with pure alcohol several
times in order to remove clogs or, if required, replace the hoses.
SPECIAL NOTE
EN
OPERATION & OPERATING PRINCIPLE
OPERATION & OPERATING PRINCIPLE | 10
