5
4.
Turn the starter key to the on position, (do not start the generator). The
battery and low oil pressure warning lamps should be illuminated.
5.
Then slowly turn the starter key to the spring position until the battery
warning lamp goes out. You should also hear the fuel solenoid click to
indicate it is open. Hold the key in this position until all the air has
escaped from the delivery valve holder fitting on the fuel pump and
diesel starts to trickle out, then turn the starter key back to the off
position.
6.
Then tighten the Delivery valve holder and the Brass injector pipe. Now
the fuel system has been bled and the generator should start.
7.
If Engine still will not start repeat steps 1-5 but turn key to start
position and diesel should squirt out of delivery valve holder. Once this
has been achieved go to step 6.
Injector pipe fitting
Delivery valve holder
Fuel filter bleed screw 1
Fuel filter bleed screw 2
5.5 Control Panel
Before connecting plugs into generator ensure the load is turned off. If this is
not possible turn the circuit breaker to the off position.
The 230v Supply is Neutral bonded to earth.
The 115v Supply is CTE. (Centre Tapped to Earth)
Turn the voltage selector switch to the required voltage.
Connect the plug/plugs into the generator.
Switch on the load / Circuit breaker.
Always turn load off before stopping generator.
