
4
4.9 Fire
Ensure that suitable fire extinguishers (AFFF or CO2) are kept within proximity to
the generator. Do not cover, enclose, or obstruct the airflow to the generator
during or shortly after use, due to fire hazard or damage to the generator from
overheating. Allow the generator to cool after use before storing away. Keep all
inflammable objects clear of the Generator.
4.10Hot Parts
There is the danger of burns as parts of the generator will become very hot
during use. No part of the engine, alternator or exhaust must be touched during
or shortly after operation.
Do not operate the generator unless all guards are in place. There is a risk of
burns or serious personal injury.
5 Operating Instructions
5.1 Pre-Start Checks
Before starting the generator please read the Yanmar engine owners manual.
Check Fuel & Oil level before attempting to start.
The generator is equipped with a low fuel level switch which will shutdown the
engine and prevent it from starting if the fuel level is low.
The engine is equipped with an oil and temperature switch and will shutdown
for low oil pressure and high engine temperature.
5.2 Warning
Do not operate the changeover switch with load connected.
Always switch load off before disconnecting plugs.
To switch power off at Generator always use circuit breaker.
5.3 Starting Instructions
Turn key to the run position Oil & Battery lamps should be lit.
Turn key to crank position until engine fires, Oil & Battery lamps should
extinguish.
Return key to run position on firing.
To stop turn key to stop position.
5.4 Fuel System Bleeding Procedure
Before attempting to bleed the fuel system on the SE6000D, ensure the key
switch is in the off position, the tank has a minimum of 10 litres of fuel and the
lid is open.
1.
Loosen the fuel filter bleed screw (1) until diesel is flowing freely
without bubbles, repeat for fuel filter bleed screw (2).
2.
Loosen the Brass injector pipe fitting (17mm nut) on the fuel pump,
move to one side, leaving the delivery valve holder (black male fitting)
on the fuel pump exposed.
3.
Loosen the Delivery valve holder (17mm) but only by 2 complete turns.