Step Electric iAStar-S3, Инструкция по эксплуатации

Страница: 104 / 200

Shanghai STEP Electric corporation
IMPORTANT
a) Acceleration D01 and deceleration D02 of S Curve may be adjusted within a specific
range. Increase of these values may improve operation efficiency but may also
impact comfort, and thus comprehensive considerations shall be given.
b) During acceleration, acceleration ini jerk D04 at the beginning and acceleration end
jerk D05 at the end may be adjusted within a specific range. Increase of these
values may improve operation efficiency but may also impact the comfort at the two
turning corners along the curve, and thus comprehensive considerations shall be
given.
c) During deceleration, deceleration ini jerk D04 at the beginning and deceleration end
jerk D05 at the end may be adjusted within a specific range. Increase of these
values may improve operation efficiency but may also impact the comfort at the two
turning corners along the curve, and thus comprehensive considerations shall be
given.
Note 4:
the impact of the parameters of S Curve on elevator operation curve is shown in
Figure 6.10. D01 and D02 determine the slope of the speed curve, the higher of which will
result in a steeper slope. D04 to D07 determine the four corners, the higher of which will
result in a smaller corner (or a higher curvature).
Figure 6.10 Impact of S Curve on elevator operation curve
Note 5:
D11 to D18 define reference speed 0 to 7 under multi-step control. The binary
codes of the three input ports of digital multi-step ports 0 to 2 may be combined to form
eight statuses, corresponding to the eight reference speeds of D11 to D1 stated above.
The correspondence is shown in the following table:
Function Parameter List
6-
18