042D07_INS0616
10
7. °STELPRO information menu: used to gain information on the product
7.1: Thermostat version
7.2: ZigBee radio version
7.3: Day of production
7.4: Month of production
7.5: Year of production
7.6: Baseboard/convector control checksum
7.7: Fan-forced heater control checksum
-
ZigBee node Id
-
ZigBee network Id
-
Reset to default
Modification of the settings:
- To gain access to the advanced settings root menu, press the UP and DOWN buttons
simultaneously for 3 seconds.
- At this point each setting (1 to 7) may be accessed by using the UP and DOWN buttons.
- To edit a value, choose a setting then simultaneously press the UP and DOWN buttons once.
Press the UP or DOWN button to edit the value.
- Confirm your choice by pressing the UP and DOWN buttons simultaneously one time at which
point the icon will momentarily flash rapidly if a change has been made.
- To exit the advanced settings press the UP and DOWN buttons simultaneously for 3 seconds at
any time. If the thermostat is left idle it will revert back to the main screen after 30 seconds
ZigBee network association (
)
Association:
Make sure the ZigBee controller is in pairing mode (refer to your ZigBee controller instruction manual).
To associate the thermostat to a ZigBee network, enter Menu 1 (ZigBee menu) and either select
(On) or the specific ZigBee channel used by your ZigBee controller (11 to 26). Then press the UP
and DOWN buttons to start the association process. During association, (On) or the specific channel
will be blinking and the connectivity icon will be animated in an increasing pattern. When the
association process has been completed, the associated channel number will be displayed solid. If an
error occurs, (Err) will be displayed for 3 seconds then the screen will revert to (Off).
