INSSTE362RNP0609
Fan mode
The activation of the fan mode is similar to the Celsius/Fahr-
enheit adjustment. To activate or deactivate fan mode, you
must press both buttons simultaneously for at least 3 sec-
onds while in day mode. Once the 3 seconds have passed,
C or F will flash. At this point, release the buttons. You must
then press on the bottom button to activate or deactivate the
fan mode. The fan pictogram will turn on or off depending
on the case.
When fan mode is activated, the stop or minimum heating
time (OFF/ON) for a complete 15 minute cycle is established
at 5 minutes. This is done to limit the amount of times the
thermostat will turn on or off. Also, if the thermostat reaches
a differential superior or inferior to the 2 degrees requested, it
will shut off before the end of the minimum heating time of 5
minutes. The deactivation of the fan mode will cause the
thermostat to go back to the heating cycle previously pro-
grammed. Once the adjustment finished, we can exit the fan
mode by not pressing on any buttons for 5 seconds.
Saving the parameters and power outages
The thermostat saves certain parameters in a non-volatile
memory to be able to recover them after being shut off (a
power outage, for example). These parameters are the Day/
Night settings, the automatization of the day/night modes,
the state of the lock mode, the maximum setting of the lock
mode, the Celsius/Fahrenheit mode, the fan mode, the ideal
changeover time of the relay and the number of minutes as-
sociated to a heating cycle, the number of hours of the night
time-switch, the number of hours remaining on the night
time-switch and the day/night current. These parameters
are saved every minute if any changes are made, except for
the Day/Night mode and the remaining time left on the time-
switch. These are saved only if the automatization of the day/
night mode had not been activated.
