INSSTCNP15MA0612
1. To deactivate the Security mode, cut off the power supply
of the thermostat at the electrical panel and wait at least 20
seconds.
2. Restore the power supply to the thermostat. The icon
will blink during a maximum of 5 minutes, indicating that
you can deactivate the Security mode.
3. In Day mode, simultaneously press down the + and - but-
tons for more than 10 seconds. The icon will then be
hidden indicating that the Security mode is deactivated.
Parameter backup and power failures
The thermostat saves some parameters in its nonvolatile
memory in order to recoverer them when power is restored
(e.g. after a power failure). These are the four set points (Day/
Night/
/
), the Smart mode, the Security mode, the maxi-
mum set point of the Security mode, the Celsius/Fahrenheit
mode, the remaining time of the timer and the maximum floor
temperature. These parameters are saved every minutes
when a change occur, except for the Day/Night mode and
the remaining time of the timer, which are saved only if the
Smart mode was not activated.
Please note that the Smart mode is not automatically reacti-
vated when the power is restored, the
icon blinks to in-
dicate that this mode was activated before the power failure
and that is now deactivated. Moreover, when the power is
restored, the Day/Night mode is recovered only if the Smart
mode was deactivated before. If not, the Day mode is auto-
matically reactivated. The Security mode is also reactivated if
it was activated before the failure. However, its icon blinks for
5 minutes and you can deactivate this mode by simultane-
ously pressing down the + and - buttons for 10 seconds. The
Security mode stays activated if you don’t follow this process
and the icon stops blinking.
15
