stellar labs Flex36 108-12, Руководство пользователя

Страница: 10 / 68

4 Flex36 Owner’s Manual
Hooklift Controls
1. Be familiar with the sequence and oper-
ation of the hooklift controls.
2. Each individual hooklift function should
have control function decals. Replace
them immediately if they are missing or
illegible.
3. Keep hands, feet and control levers free
from mud, grease and oil.
4. Be familiar with the control levers and
how they operate before attempting to
operate the hooklift.
5. Be prepared before beginning opera-
tion of the hooklift:
• All protective guards must be in place.
• Be aware of the surroundings: low
branches, power lines, unstable
ground.
• Be sure all safety devices provided are
in place and in good operating condi-
tion.
• Be prepared for all situations. Keep
fire extinguisher and first aid kit near.
• Be sure all regular maintenance has
been performed.
• Visually inspect all aspects of the
hooklift for physical damage.
• Check for fluid leaks.
Operation Overview
Unloading Operation
1. Stop the truck at the location you wish to unload.
2. Put the truck in neutral and engage the PTO.
Run RPM as needed.
3. Locate the black control lever labeled tilt.
4. Pull the tilt lever until the cylinder is fully extend-
ed, thus releasing tabs.
5. Locate the red lever labeled lift.
6. Pull lift lever until the body is on the ground and
can be detached. Return the hooklift to the
stored position and disengage the PTO.
Loading Operation
1. Position the truck in line with the body you intent
to pick up.
2. Engage the hook to the body by maneuvering
the hooklift with the red(lift) lever. Run RPM as
needed.
3. Push the red(lift) lever until the main cylinder is
fully retracted.
4. Push the black(tilt) lever until the tilt is fully
extended.
5. Disengage the PTO.
Dumping Operation
1. Stop the truck at the location you wish to dump
the load.
2. Put the truck in neutral and engage the PTO.
Run RPM as needed.
3. Locate the red lever labeled lift.
4. Pull the lever to dump the body.
5.Wait until dumping is complete, then push the
red(lift) lever until the main cylinder fully retracts.
6. Disengage the PTO.
NOTE: The controller assembly pictured in this
chapter may differ from model to model.