stellar labs Flex36 108-12, Руководство пользователя

Страница: 9 / 68

Operation 3
Chapter 2 - Operation
Job-Site Set-Up
Thoroughly plan the lift before positioning
the vehicle. Consider the following:
1. The vehicle should be positioned in an
area free from overhead obstructions to
eliminate the need for repositioning.
2. Position the vehicle so that it is impossible
for any portion of the equipment to come
within the minimum required safe distance
of any power line. Maintain a clearance
of at least 10 feet between any part of
the hooklift, load line, or load, and any
electrical line or apparatus carrying up to
50,000 volts. One foot additional clear-
ance is required for every additional
30,000 volts or less. Remember to allow
for winds that cause power lines to sway.
It is recommended that a signal person
be used when the vehicle is set-up near
power lines.
3. The vehicle should also be positioned on
a firm and level surface that will provide
adequate support for the body.
4. The parking brake must be removed to
allow the truck to roll under the body
while loading.
CAUTION
1. When loading and unloading
bodies, the tilt cylinder must be
fully extended before operating
the lift cylinder to prevent
damage to the latch systems.
2. When the PTO is engaged, do
not run the engine over 1400
RPM.
3. Do not hold the brakes while
performing operations.
Operator Requirements
Operation is limited to the following peo-
ple:
A. Qualified individual.
B. Trainees under direct supervision of the
qualified individual.
C. Test or maintenance individual.
D. Hooklift Inspector.
Operators must:
A. Demonstrate the ability to understand
all decals, the owner’s manual, and any
other information required for safe oper-
ation of the hooklift.
B. Be able to demonstrate the ability to
safely control the hooklift.
C. Know all safety regulations.
D. Be responsible for maintenance require-
ments.
E. Understand and be fully capable of
implementing all emergency proce-
dures.
F. Understand the operating procedures as
outlined by this manual, ANSI Z245 and
Federal/State Laws.
Operator Conduct
1. Operators will not engage in any opera-
tion that would cause them to divert
attention away from the operation of
the hooklift.
2. Operators are responsible for all opera-
tions under their direct control.
3. Operators will not leave a suspended
load unattended.
4. Operators will be familiar with the equip-
ment and the maintenance required for
proper care.