12 – EN
IMPORTANT SAFETY INFORMATION
•
Check the content of the package in parts list on page 2 and make sure that all parts are in order. Do not
use damaged or faulty parts.
•
Read all instructions before installing the equipment. When you are unsure about any part of the
installation process, ask a professional technician for help.
•
When tightening the screws, be careful to avoid stripping the thread.
•
Do not install on a damp or otherwise damaged wall. The assembly material supplied in the package is
designed to be mounted on a wall of bricks and concrete. For installation on walls made of other materials
consult a professional.
•
Never install or use this product if there are signs of damage.
•
The edges of the equipment may cause injury if they are handled improperly.
•
This device is not designed for assembly or handling by small children, or persons, who have not been
specifi cally instructed unless supervised by a responsible person to ensure safety during handling or
installation. Children should be supervised to ensure that they do not interfere with the equipment.
Do not allow children to hang on the equipment or otherwise handle it. Otherwise, there is a danger of
serious injury. Never insert your fi ngers or other objects into the mechanism of the equipment. It could
cause personal injuries or property damage.
•
The product contains small parts that can pose a choking hazard when inhaled or swallowed. Keep these
parts out of reach of children!
Note:
Specifi cations and design are subject to change due to improvements without notice.
LIST OF SUPPLIED PARTS
A
Body of the mount
B
Left bracket
C
Right bracket
D
Allen key
E
Screw M4×12
F
Screw M5×12
G
Screw M6×12
H
Screw M8×16
I
Screw M4×30
J
Screw M5×30
K
Screw M6×35
L
Screw M8×40
M
Lock washer M4
N
Lock washer M5
O
Lock washer M6
P
Lock washer M8
Q
Spacer M4/M5
R
Spacer M6/M8
S
Washer M4/M5
T
Washer M6/M8
U
Screw M8×90
V
Washer under the screw
W
Expansion plug M10×80
X
Locking bolt
INSTALLATION
This TVG mount must be securely fastened to a vertical wall. If not solidly installed, it
could fall and cause injury or damage.
Installing the mount on the wall of solid brick or concrete wall or panel
On the wall, mark positions of six holes (3 in upper and 3 in lower row) for attaching the mount‘s body. Use the
body
A
as a template (
Fig. 1
). Use a level to make sure the holes are horizontal and that the spacing between
each hole is at least 15 cm. Using masonry drill (10 mm) pre-drill holes at least 9 cm deep and insert expansion
plug into each hole.
W
. Check that the expansion plug is entirely inserted and even with the wall. (
Fig. 2
).
Fasten the body of the mount using six screws
U
and washers
V
, as shown
Fig. 3
.
Levelling the mount
After installing the wall mount, you can later adjust the horizontal position of the plate to mount the TV. On
the TV mounting plate loosen the screws using the Allen key and use the level to align the plate into horizontal
position. (
Fig. 4
). Once levelled, tighten the screws again (do not use excessive force).
Note:
If the TV is not entirely horizontal after installation on the mount, remove it from the mount (perform the
points from the pictures
7
and
8
in reverse order), repeat the process of levelling and then reinstall the TV set.
EN – GENERAL ASSEMBLY INSTRUCTIONS
