Stel MIGGY 171, Инструкция по эксплуатации

Страница: 13 / 27

6918900030
13
Green for 0,8mm wire.
5) Wire feed speed can be adjusted by regulating
Potentiometer 12. An increase or decrease wire
speed rate of + 20% or - 20% of selected Synergic
is regulated from Potentiometer 13.
6) To go out of Synergic MIG mode and return to
Manual MIG, press selection button 15., and hold
continuously until the light 14. is off.
PREPARING FOR MIG
WELDING WITHOUT GAS
To use a special cored wire that allows welding
without the use of gas, proceed as follows:
1) Connect the earth cable to the positive socket
(+) of the generator.
2) Insert the connector of the MIG torch in the
centralised euro socket and tighten the ring nut.
3) Check the position of the polarity changing
cable, opening the side door: for MIG welding with
special CORED WIRE without the use of gas it
must be in position "-".
Now proceed as in the instructions in the
paragraph "PREPARING FOR MIG WELDING
WITH GAS", starting from point 6, ignoring point 14
and of course all the references to gas coming out
of the torch.
FRONT PANEL DESCRIPTION
1 Machine live led
2 Welding enabled led
3 Over temperature led
4 Synergic Mode Selection Button
5 Synergic mode indicating light for 0,6-
0,8mm Mig wire
6 Potentiometer for regulating output Voltage
(MIG) and thickness material (Synergic
MIG)
7 Potentiometer for regulating welding
current (MMA-TIG) and wire speed (MIG)
8 Button Select Mode
9 Led Mode Tig 4 stroke
10 Led Mode Tig 2 stroke
11 Led Mode Tig Lift
12 Led Mode MMA
INTERNAL REGULATIONS
DESCRIPTIONS
1
Post/Gas Regulations Screw
2 Burn/Back Regulations Screw
3 Wire feed inching button
4 Gas Purge Button