Stel Iron Mig 221 MULTI, Инструкция по эксплуатации

Страница: 16 / 41

6943300010
16
1 ELECTRODE led indicating mode;
2 TIG LIFT Led indicating mode;
3 MIG 2T Led indicating mode;
4 MIG 4T Led indicating mode;
5 MULTI SPOT WELDING led indicating mode;
6 Select Mode button
7 Function Selection button;
8 Function Selection button;
9 Function Selection button;
10 Function Selection button;
11 Encoder for Voltage regulation/ other
Functions
V/SET
;
12 Encoder for Wire Speed / Amps regulation
A/ W.Sp.
13 Digital Display
SYNERGIC MODE MAIN
PAGE DESCRIPTION
14
Synergic Program chosen indication
15 Welding current indication
16 Wire Speed indication
17 Synergic Voltage Adjustment indication
18 Synergic/Manual mode indication
19 Job Mode indication
20 -
21 Multi-Functions selection
22 Thickness Material selection
23 Synergic Voltage indication
PREPARING FOR
ELECTRODE WELDING
1) Respect the indications given previously
concerning primary connection and installation.
2) Connect the earth cable to the socket of the
machine. Negative polarity ( - )
3) Connect the electrode holder to the socket of
the machine. Positive polarity (+ );
4) Insert the bare core of the electrode in the gun;
5) Press the Select Mode (ref.6) button to select
the ELECTRODE mode, indicated by the LED
(ref.1);
6) Set the welding current with the encoder
A/W.Sp. (ref.12).
7) Proceed with welding.
V.R.D. (ONLY IN MMA MODE)
The initials V.R.D. stand for VOLTAGE
REDUCTION DEVICE, which is a system for
reducing the no-load voltage (OCV). When the
V.R.D. is installed in a welding machine it reduces
the maximum no-load voltage to a safety voltage
which is normally less than 18V.
- The V.R.D. is used as an additional aid for
operator safety.
- The procedures for safety at work must always be
carried out with attention.
ACTIVATION OF V.R.D.
1) Switch on the welding machine;
2) Hold down button
Select Mode (ref.6) for about
4 seconds, then release the button; the
LED
indicating electrode mode start blinking (ref.1)
(V.R.D. FUNCTION ON Vout
18V). VRD mode remains activated when
switching the machine off and on again.
DEACTIVATION OF V.R.D.
1) Switch on the welding machine.;
2) Hold down button
Select Mode (ref.6) for
about 4 seconds, then release the button; the
LED
indicating electrode mode remains lit with a fixed
light (ref.1 (V.R.D. FUNCTION deactivated). VRD
mode remains deactivated when switching the
machine off and on again.
PREPARING FOR TIG
WELDING
1) Respect the indications given previously
concerning primary connection and installation.
2) Connect the earth cable to the socket of the
machine. Positive polarity ( + )
3) Connect the cable that exit from the front of the
machine to the negative socket ( - )
4) Connect the torch coupling to the centralised
socket of the machine. Negative polarity ( - ).
5) Connect the gas bottle to the connector
provided on the rear of the generator.
6) With the
Select Mode button (ref.6) to select the
TIG mode (ref.2)