STEIN300_Hubzentriereinrichtung_HZEV_03_GB.DOC / 02.2020
15
1
Push the HZEV from below between the edges of the two belt profiles.
2
Turn the four sliding blocks by approx. 90° so that the HZEV can be hooked
into the profile with the sliding blocks.
ATTENTION!
Ensure that the HZEV T-Slot Nuts can be guided into the profile when hanging.
Fig. 5-3:
HZEO –
viewed from
below
⇒
The HZEV has been inserted.
3
Straighten the HZEV.
4
Turn the screws with sliding blocks 90° again so that the HZEV hangs in the
profile, tighten the screws.
Fig. 5-4:
Installation measurements
Adjustment range for cylinder strokes - 15 mm
Available cylinder strokes 100, 125, 160, 200, 250,
350
PB = Pallet width
UB = Transfer width
A
Cylinder stroke – 13
B
Cylinder 260
C
Cylinder 224
D
Pallet width + 4
E
The stroke can be adjusted to 0 by moving the guide bridge.
T-slotted screw
Lifted workpiece carri-
Turn the slot nut to
hang the HZEV in
the profile!
