STEIN300_Hubzentriereinrichtung_HZEV_03_GB.DOC / 02.2020
9
Permitted WT loads are:
•
in the X axis: 0 N
•
in the Y axis: 0 N
•
in the Z axis: 400 N if the load is centred and under an operating pressure of 6 bar
260 N if the load is centred and under a STEIN operating pressure of 4 bar and
•
M=10 Nm if the load is not centred
•
No transverse forces are permitted
i
Unauthorised interventions, alterations or repairs carried out on the lift centring device
invalidate the warranty.
STEIN
Automation accepts no liability for any damage caused by unauthorised
interventions, modifications or repairs.
3.3
Residual danger
The lift centring device with extended stroke is manufactured using state-of-the-art tech-
nology and to recognised safety standards. Nevertheless their use can lead to dangerous
situations for users or third parties or to impairments of the system and other material
assets.
If used improperly, the following injuries can result:
•
Crushing may occur due to dimensions not being observed and specified pressures
being changed.
Fig. 3-2:
Crushing points
