LEET™
User
Manual
– Revision
1.7
II. DIY Builder Guide (1/3)
10
A. Remove slider from chassis
1. Unscrew 2 screws on the inside that attach
the slider’s left fan mount to the chassis
2. Unscrew 4 thumb screws on the back side
that attach the slider to the chassis
3. Carefully slide out the slider from the
chassis’ backside
1. Hardware Assembly
C. Detach front panel cables
Disconnect and remove the following cables
from the chassis’ interior:
1. USB 2.0 card reader
2. HD audio
3. USB 2.0 front display
4. Power SW and Power LED
The red-white IR cable can stay attached.
Please follow this section if you purchased the LEET chassis by itself, i.e. not a fully pre-assembled system. It
is important that you follow this guide step by step since the integration of high-end components may not
be as straight forward as with standard full tower desktop chassis.
B. Remove drive-cage from chassis
1. Unscrew 3 thumb screws that hold the drive-
cage in place
2. Unscrew 2 screws that attach the drive-cage
to the chassis’ front wall
3. Put aside the optical drive button and plate
4. Carefully lift the drive-cage out of the chassis
D. Install HDDs
1. Unscrew 4 thumb screws that fix HDDs
2. Attach rubber screws to HDDs
3. Slide HDDs with rubber screws into the bays
4. Reattach 4 thumb screws
