stefani Triple Undersink, Руководство по установке

Страница: 6 / 12

Filter housing assembly
1. Fit the mounting manifold to a suitable position using the phillips head screws
provided.
2. Remove the plastic wrap from the around the filter cartridges before placing it into the
housing
3. Screw the filter housing onto the manifold in a clockwise direction to the end stop. Use
the wrench provided and ensure the depth gauge washer cannot fit into the gap as
shown on the instructions attached to the wrench.
INSTALLATION INSTRUCTIONS STEP 2
CAUTION !
Please use this metal piece as a guage to varify if the
IN
Met al piece fits he re
Must be on IN side
Housing side
Important notes on1/4 inch tubing:
• When cutting the ¼ inch tubing, ensure the cuts are square and clean, other
wise leaking may occur
• When connecting the tube to the quick connect system, ensure you push the
tube all the way to the end, and pull slightly to seal the connection
• To Disconnect, push the tubing in, press and hold collar against fitting, pull tube
out of fitting.
6
housing is well tightened to avoid any leakage occurring