SteelMax SM-BM-16, Руководство оператора

Страница: 12 / 32

SM-BM-16
SM-BM-
16 Operator’s Manual
12
3.5. Operating
Connect the machine to the power source and put the machine on the left side of the
workpiece as shown in the figure. Make sure that the milling head is not in contact
with the workpiece. Make sure that the workpiece is stable and well clamped.
To start the motor, press and hold the switch lock and the ON/OFF switch, and
then release the lock. Wait a few seconds until the machine reaches the required
rotational speed. Then, press the machine to the workpiece with both hands and
slowly move to the edge until the tool starts cutting. Move the machine from left to
right (counter-rotation). The arrow on the guide shows the rotation direction of the
milling head.
Start with making small bevels (3
–4 mm, 0.12–0.16″) and increase the bevel
width with experience. Bevel in at least two passes. Set the bevel width to a value
that will allow the feed of one meter per minute without much effort.
If an overload occurs, the motor stops. This can happen when the bevel width is
too large for the hardness of material or when the cutting inserts are dull. Thus, to
prevent overload, machine hard materials in multiple passes and replace the inserts
before they become dull. Also, take periodic breaks during work and keep the air
vents unclogged. This prevents overheating and damage to the windings.
After the work is finished, release the ON/OFF switch to turn off the motor. Then,
wait until the rotation stops and unplug the machine from the power source.
Clean the machine with a cotton cloth and no chemical agents.
Feed direction
Switch lock
ON/OFF switch