SM-BM-16
SM-BM-
16 Operator’s Manual
13
3.6. Replacing the cutting inserts
Unplug the machine from the power source. Loosen the clamping screw (
1
)
to get
access to the milling head. Then, rotate the sleeve to the right to lower it as
far
as
possible
(
2
).
Then,
use
the
screwdriver
supplied with the milling head to remove the
screw (
3
) and the cutting insert (
4
). Clean the socket, and then rotate the insert and
install again or replace with a new one
if
all
possible
to use edges are worn. Next,
push and tighten the insert. Make sure that the bottom of the insert is in full contact
with the surface of the socket (
5
).
Before you replace the cutting inserts of the radius milling head, loosen the roller
as described in “Removing and installing the roller and the milling head”.
Clean
the
threads
once
a
week. If
necessary, put grease on the
fixing
screws
for
inserts. Use an agent (for example copper
paste) that
prevent
blocking of the screws.
3
1
2
4
5
INCORRECT
CORRECT
CORRECT
Содержание SM-BM-16
Страница 18: ...SM BM 16 SM BM 16 Operator s Manual 18 2 1 3 4 ...
Страница 24: ...SM BM 16 SM BM 16 Operator s Manual 24 6 WIRING DIAGRAM ...
Страница 28: ...SM BM 16 SM BM 16 Operator s Manual 28 ...
