SM-S-9 XP Operator’s Manual
- 23 -
2017 Version 1.01
Replacing Carbon Motor Brushes
► Caution: Disconnect plug from power supply before servicing your saw.
Your saw’s carbon motor brushes must be replaced when they are worn down to 6 mm or less in
length from the brush spring. Be sure brushes are clean and slide freely in the brush holder.
Always replace both carbon brushes at the same time. Never repalce just one of the brushes. Use
only approved repalcement brushes. Use a flat-blade screwdriver to remove the brush holder cap
(A) and remove the worn carbon brushes (B). Insert new carbon brushes and re-secure the brush
holder cap.
Fig.25
.
