ARC Runner
ARC Runner Operator’s Manual
13
To position the carriage closer to the workpiece,
use
the
3
mm
hex
wrench
to
unscrew the roller assemblies. Next, install them at the other end of the guide arms,
and then swap the guide arms (Fig. 3).
Switch the magnet ON/OFF
lever from left (‘O’) to right (‘I’). This will change the
clamping force from
minimum
to
maximum.
Loosen
the
levers
to adjust
the position
and
angle of the torch. Use two knobs at the cross slide to precisely set the torch
position.
At heights, attach a fall arrester (not included) to a lug (Fig. 3) to prevent the
carriage
from
falling.
This
will
avoid
possible
injury
to
the operator in case the carriage
loses the clamping. Do not stay below the carriage placed at heights.
Содержание ARC Runner
