6
PRE-START CHECK
FUEL LEVEL
WARNING! Make sure there is enough fuel in the fuel tank before
operating.
1) If it is necessary to add fuel, first make sure the engine is OFF, then
remove the fuel cap by turning it counterclockwise.
2) When refueling, keep in mind all safety precautions and make sure to add
enough fuel based on usage. Use clean unleaded gasoline with a minimum of
87 octane. Do not mix oil with gasoline.
AIR CLEANER FILTER
The air cleaner filter should be checked after prolonged storage, the following
steps should be done when checking air cleaner filter;
1) Snap the top and bottom clips backwards and remove the air cleaner cover
(A) Fig.7.
2) Remove the air cleaner filter (B) Fig.7, wash filter in kerosene, squeeze
kerosene out, soak filter in engine oil and squeeze engine oil out.
3) Replace filter and replace the air cleaner filter cover.
START-UP PROCEDURES
Follow these instructions to safely start your high pressure washer.
1) Check engine oil level, fill to recommended level if necessary.
2) Check gasoline level, fill if necessary.
3) This pressure washer comes with a pump quick connect coupling. It
allows you to quickly connect or disconnect the inlet garden hose from
the pump. Pulling the mid ring will disconnect the quick connect coupling.
Connect inlet garden hose (not supplied) to the pump quick connect coupling
AND TURN WATER ON The water supply must provide a minimum
of 4 GPM at 20 PSI or the pump may be damaged.
4) Squeeze stainless steel wand trigger. This will allow air to escape
from the hose in order to prime the pump. Squeeze trigger until there is a
steady flow of water.
fig. 7
