5
ASSEMBLY & PRE-START CHECK
WARNING! Before turning on your pressure washer engine, you MUST
check oil level, fuel level and air cleaner filter.
ASSEMBLY
Remove all the contents from the carton and proceed to the following assembly
instructions;
Top handle
Install the top handle (A) to the frame (B) by sliding the top handle posts
into the frame posts and secure them together using 2 pan head screws, 4 gaskets
and 2 nylon hex. nuts.
Wheels
Install the wheels to the frame by first pressing its spring loaded pin, then
insert wheel axial into frame and align spring loaded pin with hole in frame
until the pin snaps. Repeat for the other wheel.
Hose and wand supports
Assemble the hose support (C) Fig.1 to the right side of the frame using 2 pan
head screws, 4 gaskets and 2 nylon hex. nuts. Then assemble the wand
support (D) to the left side of the frame again using 2 pan head screws, 4
gaskets and 2 nylon hex. nuts.
Wand and hose
Assemble the 2 piece stainless steel wand (A) Fig.2. Lower the rubber piece
(B) to expose the threaded fitting and screw the 2 pieces together, reposition
the rubber piece. It is recommended to install Teflon tape on the threads to
prevent water leakage. Next install the hose (A) Fig.3 to the wand (B) and
install the other end of the hose (C) Fig.3 to the pump outlet (D) as shown in
Fig.4. It is recommended to install Teflon tape on the threads to prevent
water leakage.
Quick connect coupling
Install the quick connect coupling (E) Fig.4 to the water hose inlet (F). It is
recommended to install Teflon tape on the threads to prevent water leakage.
PRE-START CHECK
OIL LEVEL
WARNING! This pressure washer has been shipped from the factory
without oil or very little oil in the crankcase. Operating the unit
without the correct amount of oil can damage the engine. Oil
crankcase capacity: 0.6 litres. Always check the oil level before
starting the engine, make sure the pressure washer is on a level
surface. To check oil level;
1) Turn the oil gauge dipstick (A) Fig.5 counterclockwise, remove it and clean it
with a clean cloth.
2) Fully reinsert the oil gauge dipstick and pull it out to check the oil level.
3) If the oil level is halfway up the dipstick or below, refill with SAE 10W30 oil
through the dipstick hole until the oil level reaches 3/4 up the dipstick or until it
reaches the bottom lip of the dipstick hole as shown in illustration below.
4) Reposition the oil gauge dipstick and tighten it by turning clockwise.
A
C
D
B
fig. 2
Wand
E
fig. 4
