Steel City 10-722, Руководство пользователя

Страница: 20 / 36

Page 20
◊ CHECKING AND ADJUSTING SAW
BLADE SqUARE TO TABLE
1. Place the cutterhead in a cross-cut position. Lower
track arm until the saw blade is just clear of the table
and slide the carriage forward until it is positioned over
the front table board; clamp the carriage in position .
2. Remove the hose and outer blade guard.
3. Make certain the bevel index knob is engaged and the
motor is in a horizontal position. Tighten bevel clamp
handle.
6. If an adjustment is necessary, loosen nuts, adjust
screws until the blade is square to table.Tighten lock
nut.
7. Adjust pointer to “zero” on the bevel index scale.
8. Replace the outer blade guard
4. Place a square on the table and against the saw blade,
between two teeth of the saw blade and check to see if
the blade is square with the table.
Lock lever
Set
screw
Lock nut
2. Remove the hose and outer blade guard.
4. Same process on
back side.
5. Replace end plate
on the track-arm.
3. Loosen screw in front and the jam nut under. Turn the
bolt in the required direction until the bottom bearing are
leaning against the rails. Unlock the carriage to make a
test by moving it.
Screw
Jam nut
Bolt
Rail
Note: Adjust only enough to eliminate play – do
not over tighten as this can stiffen or restrict
carriage travel, requiring more effort to move it
and cause premature wear of the rails.