Stealth Products Multi Joystick, Руководство пользователя

Страница: 23 / 36

R-net Settings 11.0
16
JOYSTICK DEADBAND
The Joystick Deadband parameter defines how far the joystick must be moved from its default (center)
position to engage the motors of the wheelchair. The value corresponds to the diameter of a circle
around the joystick's default (center) position. No driving or menu instruction will be executed unless
the joystick is moved out of the center deadband circle.
SETTING THE JOYSTICK DEADBAND
1. Plug the R-net programming dongle into an available port in the R-net system.
2. Power on the chair.
3. Connect the PC to the Programming Dongle with the USB cable.
4. Start the R-net PC Programming Software on your PC.
5. Select Read from Controller to load the information from the R-net system to the Configurator
6. Parameter is set under Controls > Joystick > Joystick Deadband. (Values range from 10% to
7. Select Write to Controller to save the changes to the R-net system.
8. Power cycle the chair (turn it off, then back on) to load the new parameters.
Profile parameter Supported Version Solutions
Invert left/right JS axis Y V02.01
Invert fwd/rev JS axis Y V02.01
Swap joystick axis N
Use rotate
function in the
mo-Vis Configurator
Change mode while
driving
Y V02.00
Sleep timer Y V02.00
Standby timer Y V02.00
Switch to standby Y V02.00
Mode selection in
standby
Y V02.01
Standby in modes Y V02.01
Standby forward Y V02.00
Standby reverse Y V02.00
Standby left Y V02.00
Standby right Y V02.00
Remote selection Y V02.03
Background N
No screen
to support this.