Steadicam ARCHER2, Руководство по эксплуатации

Страница: 8 / 36

8
The Stage
8
Stage mechanics and adjustments
The dovetail clamp lever has
three positions: forward and
locked, 90º for adjustments,
and 60º back for mounting
or removing the dovetail
plate. A safety button must
be pushed to move the lever
to the unlocked position; the
same button holds the lever
fully open, making flips to
low mode and back a bit
easier. Do not force the lever
backwards beyond its stop.
The stage is easy to adjust. The knob at the right
rear controls fore and aft, and the two knobs on
the side control side to side movement.
The stage connectors
At the rear of the stage, left to right (port
side to starboard side):
• Camera power connector. 3 pin Lemo,
+28V, +14V, and ground.
• Video out/regulated 12V Power.
4 pin Hirose
• HDSDI video in BNC
• Composite video in base of sled. BNC
• Power for focus motor receiver/amplifiers.
3 pin Lemo (+28V, +14V, and ground)
• Tally light connector (additional functions
possible)
Nosebox starboard side:
• Pot to adjust Tally sensor sensitivity
Side to side
adjustment knob
Fore and aft
adjustment knob
Note: The Archer
2
can be ordered
without a motorized stage, or
with a single motor, or with two
motors. Upgrading to one or two
motors is a simple “plug-and-play”
operation.
Under the stage where the post meets the
tilt head:
• Two SMB connectors for two of the three
RGB lines
At the front (nosebox), left to right:
A
rcher
2