Steadicam ARCHER2, Руководство по эксплуатации

Страница: 14 / 36

Smart
Motorized
Stage
14
Charging the remote
If the transmitter’s battery is low, the
LED will blink continuously after any
button is depressed. To charge the remote,
remove it from the gimbal handle. Plug
the supplied cable into the remote and
the other end into either one of the 4-pin
HRS connectors on the sled.
Leave the sled on as you charge the
battery. It takes about 5 hours to charge
a completely discharged remote battery.
When the battery is charging, the green
LED will be on. When the lithium-ion
battery is fully charged, the green light
goes off.
If plugging in a fully charged transmitter,
the LED will remain lit for approximately
ten minutes until the charge circuit
determines the battery is actually full.
Battery life can vary depending on how
often the transmitter is used and the
storage and operating conditions.
Changing the frequency
To avoid interference with other systems,
1 of 8 channels can be selected via the
rotary switch on starboard side of nose
box.
The remote and the receiver must be
on the same channel. Simultaneously
holding down the top 2 go-to buttons
for 6 seconds will enter the remote into
a channel change mode. The number of
LED blinks will correspond to channel
selected.
Change channels by pressing the fore or
aft remote buttons (channel up or down).
After the proper channel is selected, the
programming mode will time out after 9
seconds and re-flash the selected channel
number. Channel 0 corresponds to 8
flashes.
(For operation outside of the USA) To
select between US and UK frequency
operation, there are two jumpers that
must be changed. One jumper is inside
the nosebox, the other is inside the
remote. They must match for the system
to work. The jumpers are set at the
factory at the time of shipping. (902 –
928MHz US and 868 to 870MHz UK)
The green “PWR” LED on nose box
comes on when the CPU is operational.
A
rcher
2