Starwood SA 315B Lama, Инструкция по сборке

Страница: 8 / 21

8
. Mount your tail rotor servo. Refer to drawing below for pushrod location and place the tail
pitch control rod and tube in position on the tail boom. Once in place attach one end to the Tail
Rotor Gearbox, the other to your servo arm. At each Cross member along the tail boom
TIE the
pushrod outer tube in place with multiple wraps of thread (DO NOT GLUE YET!). After
adjusting the pushrod tube and rod for proper smooth function and correct location. Check the
alignment from servo arm to tail box. When you are satisfied all is the proper location, place a
drop of CA on each thread wrapped location along the tail boom. This will tack the push rod in
place. Add a dab of 2 part slow epoxy to all thread/ CA connections for additional strength.
Hint:
You can remove the tail push rod connection at the servo when you think everything is
aligned, but before final gluing. The tail push rod can then be moved and felt for minimal
friction while moving. Try to obtain as little drag as possible before gluing the tail push rod in
place.
9.
Locate the four wood cabin formers. Assemble the formers upside down on a flat surface
with a piece of wax paper under the formers. Square the formers to each other and tack together
with medium CA glue. When you are sure formers are square to each other run a bead of CA
along the former joints and let the CA set. Turn the former assembly over (floor side up). Trial
fit to inside of the cabin. Former assembly will not be a perfect match to the bottom of the
cabin. The formers will however sit parallel and about 1/8” below the edge of the door
bottoms. The floor boards, when installed, should end up flush along the door bottoms. Add ¾
x ¾ rails to either side of the front to back formers. See Fig 9, 13, 17
Pg 7