Starwood SA 315B Lama, Инструкция по сборке

Страница: 13 / 21

13
. Please double check that the cabin stand offs at the side of framework (behind cabin)
measures 22 mm at the short point. See Fig 15& 16. Extend the stand offs with brass tubing
glue in place and glue with 2 part slow epoxy as necessary.
Fig 15
Fig 16
14 . You should now be able to slide the cabin onto the forward projecting, lower horizontal
mounting tubes mounted to the main frame system.
15 . There will be a gap of approximately ¾ inches between the horizontal mounting tubes on
the main frame and the rear wooden rails in the cabin. Use two small scrap blocks of wood
(not supplied) approximately ¾ x ¾ inch to create a snug fit between the wooden rails and the
metal mechanics tube beneath it. Add some thin shims as necessary. Ensure the cabin door
bottom rails are level with the mechanics framework and landing gear. Double check all is
correct and
tack glue the shims to the spacer blocks with CA. Do not let the CA run down
and glue the blocks to the metal rails! The cabin must be free to slide on and off sitting on
the two bottom rails
. See Fig 17
After the CA has set, you can remove the cabin and epoxy the spacer blocks in place.
Pg 12