Start italiana MAGLINK 16T, Руководство по установке

Страница: 36 / 48

Maglink 16T rev.08 2015-07 - ENG
36
When an alarm occurs a discontinuous beep is alerted and the event is stored into the SD card. Alarms need to be acknowledged,
pressing ESC key. This action will store the ACK event
into the SD card and the sound will be cleared.
If the alarm is restored by itself the beep will finish and the event will be stored into the SD card.
Lines can be of 3 different colors:

RED: alarm occurs NEW

YELLOW: alarm acknowledge ACK

GREEN: alarm cleared CLEAR
With UP and DOWN keys the alarm list is scrolled showing the last 150 stored alarms.
But there is no limit to the alarm stored into the SD card.
Date, time, tank number, alarm code and status are stored into the SD card.
Alarm codes listed as follow:
01 No Probe Link Probe not answering, check address or cabling
02 High Product level is over value H but under value HH if different from 0
03 Low Product level is under value L but over value LL if different from 0
04 Out of Range
Product level is over the last value of the strapping table. It is not possible to calculate the
volume because data are missing
05 Probe Probe is answering without valid measure. Check floats, bendings
06 High High Product level is over HH value
07 Low Low Product level is under LL value
10 Water Water level is above the set value
00 No alarm No alarm
12 Water + High Water alarm + High product alarm combination
13 Water + Low Water alarm + Low product alarm combination
16 Water + High High Water alarm + High High product alarm combination
17 Water + Low Low Water alarm + Low Low product alarm combination