Start italiana MAGLINK 16T, Руководство по установке

Страница: 23 / 48

Maglink 16T rev.08 2015-07 - ENG
23
WRITE DATA ON DEVICE
This button allows to transfer the information defined on the software of the console.
This operation must be repeated for each channel to be settled. If the channel is
changed without transferring data to the console those new data will be lost.
TANK
Select channel (tank) to be configured.
After connection the rectangle on the right must be green. This shows proper
connection.
During data downloading the rectangle becomes red to show communication in
progress. At the end of downloading the rectangle must become green again.
SYSTEM CONFIGURATION
SYSTEM
Total channel
Write the total number of channels from 1 to 16.
Total fuel
for future use
Total slave
for future use
Total sensors
number of sensors ON-OFF used for man-hole, sump, It is possible to
connect up to 16 sensors ON-OFF on the bus. Please pay attention on
the maximum connection capacity on a single barrier.
Protocol type:
Protocol type enabled on the RS232 for management system
connection. Common available protocols are: GILBARCO, TOKHEIM,
PIGNONE, TOPLEVEL, Probe emulation, RETALIX, DIALOG, ORPAK,
TOREX, TLG-SMITHS
Probe resolution (mm/inc) Parameter used for leakage detection. Modify this parameter if false alarms occur.
DVD sleep time (min)
for future use
Unit of measure
millimeters-liters or inches-gallons
STATION
Station name write the name of the station.
History interval (min)
Elapsed time for historical writing on the Micro SD card (if inserted
into the console). All data, alarms, movements, delivery, leakage are
written into a txt file inside the SD card internally located. Configure
at 10 minutes in order not to have too many data to be managed
which could cause an excessive slow down.
Delivery timer (S)
Linked to delivery liter/gallons parameter, configure at 60 secs to
have liter/min in calculation.
Vol. comp. temp.
temperature for calculation of the compensated volume. The default
value is 15.
MAGLINK language
select the console language.