SR200
Specifications subject to change
3.3
If multiple parameters have been selected they may not fit on the display. To continue viewing
the remaining results, click on the SELECT
key.
To cancel a measurement
If Measure is pressed during a traverse, a stop and reversal without measurement will occur
and Measurement Cancelled is displayed.
Using the SR200 with a PC
If the SR200 is connected to a PC then measurements will be taken in dump mode, which
is selected using the SCROLL
and SELECT
keys from the main menu (see next
chapter for full set-up details). Position the Pickup stylus on the component to be measured.
Measurements are then activated from the software on the PC. When the measurement is
completed the pickup returns and the results are dumped directly to the PC. During transfer of
the measurement data the message Data Dumping is displayed.
When the data dump is completed, the dump menu still remains active. From the displayed
menu, values of evaluation length and range can be changed and further measurements for
data dump can be made (see next chapter for further details).
Printing
key: pressing this key causes the evaluated measurement data to be output to the
RS232 port. When a printer is connected, a printout of all the parameters selected in the print
menu is made.
If SPC has been selected (see chapter 4) the heading is disabled.
Where the profile is longer than 80cm the printout will stop after 80cm. Pressing PRINT key
can print the next 80cm. The printout will start from the beginning of the profile if SELECT is
activated.
If no legal surface data is stored, the error message “Measure before print” is displayed.
To cancel print
Pressing the PRINT
key during printout (before display has updated to Main menu state)
stops the printout and “Printer cancelled” is displayed for 2 seconds. The normal update to
Main-state then continues.
Rapp Industrial Sales 724 789-7853
