Part Number: 3601 / 3651
Page 2
Version 1.0
© 2019 Starkey Products, Inc.
Remove black panel shown. Save
8 retaining pins for re-install later.
4
Be sure that the nut is re-attached
tightly.
5
Make sure tan fuse is seated
properly in slot (position 66).
6
Wiring in Engine Bay:
1.
Remove the battery cover on the passenger side. It is held on by 3 caps that you can unscrew by
hand. Lift cover off and save for re-attachment later.
2.
Disconnect negative (black) battery cable from the car battery. This is done by loosening the bolt
located on the side of the battery cable terminal with a 10mm socket or wrench. You may let the
cable sit off to the side. Make sure the cable has been disconnected! Do NOT allow it to make
contact with the +12v Red battery cable!
3.
Remove the black panel which covers the radiator shown in picture 4. The panel is attached by 8
push pins. See picture 2. Save pins and black panel for re-installation later.
4.
Locate the fuse box. It is located behind the passenger side head light. Open the access cover.
5.
Connect the
orange
wire to the +12 volt power cable entering the fuse box circled in picture 5. A
10mm socket or wrench can be used to remove the nut holding the power supply cable. A ring
terminal is located at end of the
orange
wire which will slide over the post. Re-attach nut tightly.
While tightening be careful not to allow your wrench or ratchet to come in contact with any other
metal object such as the car body.
6.
A fuse tap is included in the parts bag. It comes pre-installed on a 5 amp tan mini-fuse to ease
installation. Remove the existing fuse from position 66 in your fuse box. Refer to pictures 5 / 6 / 7
or the vehicles owner manual for proper fuse location. It is critical that you connect to the proper
fuse.
7.
Install the replacement mini-fuse/ fuse tap.
8.
Plug short red wire coming from wiring harness into the fuse tap you just installed. Route the red
wire out of the fuse box as shown in picture 7 below.
9.
Use an 8mm socket or wrench to attach the
black
ground wire ring terminal to the bolt shown in
picture 8. Re-attach the bolt so the ring terminal makes proper contact and the bolt is tight.
Plug-in red wire and route out of
box. Arrow shows orientation.
7
Attach ring terminal to bolt
circled above. Firmly re-tighten.
8
Push boot carefully out of the
firewall. Pass wire through.
9
