STORAGE
For storing the air compressor, be sure to do the following:
1. Turn the unit off and unplug the power cord from the receptacle.
2. Remove all air hoses, accessories, and air tools from the air compressor.
3. Perform the daily maintenance schedule.
4. Open the drain valve to bleed all air from the tank.
5. Close the drain valve.
6. Store the air compressor in a clean and dry location.
WARNING
The air compressor should be turned off and unplugged from the power source before any
maintenance is performed as well as the air bled from the tank and the unit allowed time to cool. Personal injuries
could occur from moving parts, electrical sources, compressed air or hot surfaces.
TROUBLE SHOOTING GUIDE
The air compressor should be turned off and unplugged from the power source before any maintenance is performed
as well as the air bled from the tank and the unit allowed time to cool. Personal injuries could occur from moving
parts, electrical sources, compressed air, or hot surfaces.
Problem
Possible Correction
Air leaks at the check valve or
at the pressure relief valve.
A defective check valve results in a constant air leak at the pressure release valve
when there is pressure in the tank and the compressor is shut off. Drain the tank, then
remove and clean or replace the check valve.
Air leaks between head and
cylinder.
Be sure of proper torque on head bolts. If leak remains, contact a service technician.
Air leak from safety valve.
Operate the safety valve manually by pulling on the ring. If the valve continues to leak
when in the closed position, it should be replaced.
Pressure reading on the
regulated pressure gauge
drops when an accessory is
used.
If there is an excessive amount of pressure drop when the accessory is used, replace
the regulator.
NOTE:
Adjust the regulated pressure under flow conditions (while accessory is being used). It
is normal for the gauge to show minimal pressure loss during initial use of the tool.
Excessive tank pressure.
Move the Auto-On/Off lever to the Off position. If the unit doesn't shut off, unplug it from
the power source and contact a service technician.
Motor will not start.
Make sure power cord is plugged in and the switch is on. Inspect for the proper size
fuse in your circuit box. If the fuse was tripped reset it and restart the unit. If repeated
tripping occurs, replace the check valve or contact your service technician.
Excessive moisture in the
discharge air.
Remove the water in the tank by draining after each use. High humidity environments
will cause excessive condensation. Utilize water filters on your air line.
NOTE:
Water condensation is not caused by compressor malfunction. Be sure the
compressor's air output is greater than your tool's air consumption rate.
Air leaks from the tank body
or tank welds.
Never drill into weld or otherwise modify the air tank or it will weaken. The tank can
rupture or explode. Compressor cannot be repaired. Discontinue use of the air
compressor.
Содержание 65168
Страница 6: ......
