Starcraft STARFLYER 2015, Руководство пользователя

Страница: 60 / 152

SECTION 4 – TOWING & SET-UP STARCRAFT TOWABLE
4-10
3. Type in the keypads existing code, for example 1234 , then press lock . (1234
is the default code from the factory and only works until it has been changed.)
4. Now type in the new code written below (up to 8 digits), then press lock .
5. Again type in the same new code as written below and again press lock .
(Repeat until a long confirmation beep from the keypad confirms and
completes programming.
6. Test to ensure your new code works by typing in your new code and press the
lock/unlock button . The Keypad should confirm the accepted code by a long
beep. If not, start again at step #1.
NOTE: The keypad will function best when within a close proximity of the door
handle. Position the door as close to the keypad as possible during this process.

The keypad will reset to former operation after 10 seconds of being idle during
programming mode. If you make a mistake wait 10 seconds and start over.

Long beep – Confirmation/Functioning

5 short beeps – Error/Wrong code

You must ALWAYS have the current code to change to a new one. There is
no reset button or override code. If the code has been forgotten, the Keypad
must be replaced.

Always keep your keys OUTSIDE of your coach in case of electronics/battery
failure.

The CR2032 battery can be accessed by removing the 2 screws that hold the
battery door in place on the bottom of the keypad.

After installing a new battery, make sure to press battery door in firmly when
tightening screws. This will allow the gaskets to seal up tight. Not pressing the
battery door securely while tightening may result in water being able to
access the interior of the keypad.
New Code: - Code can be between 0 and 8 digits, we recommend at least 4 digits
for security.
Syncing the lock handle with your keypad
1. Lightly press the learning button with a paper clip through the pin hole
located under the interior handle. A beep will confirm that you have entered
the programming mode.
2. Repeat typing in your numeric code and pressing the lock button until
the handle confirms with a series of rapid beeps. (Usually takes one or two
times)

Default code for all new keypads is 1234. If you would like to change your
keypad code see
“Programming a new code into your keyless entry
system” above after completing this “syncing” process…

If programming did not work, repeat steps 1 and 2.
Changing the Batteries on your lock handle
Remove the two (2) screws holding the battery cover and install four (4) AA
alkaline batteries. NOTE: Install high quality, fully charged alkaline batteries.
Batteries should last 6 months in between changes. Remove batteries at the end
of the season and/or during large gaps between trips to avoid draining batteries
and possible damage.
A beep will confirm that the handle has power. Replace the battery cover and
screws. (DO NOT OVERTIGHTEN).