Stara TORNADO 600MD, Инструкция и каталог запасных частей

Страница: 20 / 40

6.2 - Drive-Shaft Mounting
Raise the implement until the drive-shaft reaches the same height of the
tractor’s PTO (Figure 08).
Place half of the drive-shaft on the side of the implement, and the other half
of the PTO, placing them side-by-side, to adjust their length.
If the drive-shaft is too long, cut the tube to the same length (Figure 09).
The two tubes (male and female), should have the minimum gap of 25mm
on either side (Figure 09).
Avoid over-cutting the tubes, thus maintaining an area of engagement
between the male and female, in case of maximum drive-shaft span, or be it, when
the implement is elevated to major heights.
Remove dirt and grease of the thinner tube’s external side.
o
ATENTION! The drive-shaft angle should never exceed 30 , when in the
working position (Figure 10).
Figure 10
0
max. 30
Figure 09
Min.
25 mm
Min.
25 mm
13