Stara TORNADO 600MD, Инструкция и каталог запасных частей

Страница: 18 / 40

6 - HOOK-UP, ADJUSTMENTS AND PROCEDURES
ATTENTION! Before hooking-up and operating the implement follow these
procedures :
- Verify that the inside of the reservoir is clean of all foreign objects. Remove it,
should you find any foreign objects.
- Remove the transmission main oil plug and replace it with a breather, as
shown (Figure 04).
- To check the gear box oil level, place the implement on a level surface and
remove the rear end plug (Figure 04).
6.1 - Hooking-up the Implement to the Tractor
The Tornado 600MD, in principal, can mount on any tractor possessing a
hydraulic lift.
To hook-up the spreader to the tractor, follow these steps:
1st) Dis-arm the tractor traction bar and move it to the side, or remove it
completely, leaving room for the drive-shaft.
2nd) Hook-up the implement onto to the 3-points of the tractor hydraulic
system. The mounting pins of the Tornado 600MD where made for two types of
categories I and II (Figure 05).
ATTENTION! It is important that the arms of the 3rd point and of the two
side braces (Figure 06), should be adjusted with the maximum slackness of 5 cm,
so that these items will not interfere with the tractor’s tires.
3rd) Level the implement in relation to the terrain. Checking all sides so that the
implement is leveled (Figures 07 and 08), also verify that the distance of the disc to
the ground should be 75 cm (Figure 08).
Figure 04
Replace the Main Oil Plug
with a Breather.
Rear End Plug
(check oil level)
11