STAR TRAC FITNESS Pro Tread AC 7600, Руководство по обслуживанию

Страница: 36 / 68

Service Manual: E-TR and E-TRi 34
MAINTENANCE MODE – AUTO CALIBRATION
Electrical voltages vary between locations. The treadmill can run through an auto-calibration process
to allow the electronics to balance out with the speed control.
To run an auto-calibration procedure, do the following:
Auto-Calibration
DO NOT LEAVE THE TREADMILL UNATTENDED WHILE RUNNING
THE AUTO-CALIBRATION PROCEDURE AS IT WILL RUN THE
BELT TO THE MAXIMUM SPEED SETTING.
1. Enter the Maintenance Mode (see “Engaging Maintenance Mode”).
The display will read:
2. Enter the Motor test mode by pressing the ‘8’ key once. The display
will read:
3. Start the auto-calibration process by pressing the ‘Forest’ key once
and immediately stepping off of the treadmill.
The center number (3) as shown above, will begin to increase, running
belt will move and the center number will on the right hand side of the
display (0.0) will move .
The treadmill running belt will begin to move in the following manner:
•
Running belt will move, center number will increase and the
numbers on the right hand side of the display ‘0.0’ will move