3-2-4. Ethernet Cable
If a ferrite core is included, install the ferrite core onto the Ethernet cable according to the following procedure to
prevent electrical noise.
If a ferrite core is not included, perform steps (1) and (5) only.
When using an Ethernet cable that is 10 cm or less, shielded cable is recommended.
g
Link disconnection detection feature
The Ethernet interface model is equipped with a link disconnection detection feature.
If the printer is turned on when an Ethernet cable is not connected to it, the POWER and ERROR lamps are simul-
taneously turned on and off at 4-second intervals to indicate the disconnection.
Be sure to connect the Ethernet cable from a PC or hub to the printer, and then turn the printer on.
(1) Make sure the printer is turned off.
(2) Install the ferrite core onto the ethernet cable as shown in the illustration below.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it. Use scissors to cut off any excess.
(5) Connect the interface cable to the connector on the rear panel of the printer.
-
10
-
Ethernet cable
IFBD-HE07
10 cm
(maximum)
Fastener
Ferrite core
Ethernet cable
Ethernet cable
IFBD-HE05
Содержание TSP743II Series
Страница 1: ...THERMAL PRINTER TSP700IISERIES Hardware Manual...
Страница 33: ...URL http www star m jp eng Rev 1 8...